A Truss or Lattice Girder may be formed from almost any combination of steel sections including: Hot Rolled Sections Square, Rectangular or Circular Hollow Sections, and – Cold Formed Profiles In this article, we’ll look specifically at Hot Rolled Sections including: Angles, Channels, Tees and I / H profiles, both Bolted and Welded. The one
Truss Girders – Nodes and Work Points Read Article »
A typical Truss is comprised of the top and bottom horizontal members known as the Chords – the vertical members are either the Ties of Struts, depending on whether they are in Tension or Compression, while the diagonal members form the Lacing. The distance between the intersection points (known as the Nodes) of the Lacing
Truss Girders – Setting Out Read Article »
Introduction A Truss or Lattice-Girder is essentially a triangulated system of interconnected elements which connect at common work-points or ‘Nodes’, they are designed to primarily resist bending with the top chord being the compression element, and the bottom chord being the tension element. The diagonal lacing being axially loaded will work either in tension or
Truss Girders – Introduction Read Article »
